FOREND: Trim piece to fit profile of forend. RELIEF CUTS may be necessary at front or rear edge of pieces to conform to forend taper. See Diagram Below. Make sure to cut out any ejection ports you may have on the Forend area.
BARREL: Pieces should be started at a point towards the front of Barrel behind Site. Using firm finger pressure, conform to barrel being sure to overlap at bottom of barrel.
1 - 54” x 11.5” page with 4 - Pre-Cut Pieces
(2) Stock & Receiver, (1) Forend & (1) Barrel (up to 32")