FOREND: Trim piece to fit profile of forend. DO NOT WRAP AROUND EDGES! Relief Cuts may be necessary at front or rear edge of pieces to conform to forend taper. See Diagram Below.
RECEIVER: Line up matching pieces to rear edge of receiver in front of pistol grip. Make sure bottom of piece aligns with bottom of receiver. Make a RELIEF CUT in top of piece as indicated on Diagram Below. Use firm finger pressure to apply, overlapping cut area slightly. Trim with sharp razor blade at front of receiver and ejection port.
BARREL: Pieces should be started at a point forward of rear barrel pieces. Peel Liner from piece, and using firm finger pressure, conform to barrel being sure to overlap at bottom of barrel. It may be necessary to trim edge to fit around barrel lug.
1 - 54” x 11” page with 6 - Pre-Cut Pieces
(2) Stock, (2) Receiver, (1) Forend & (1) Barrel (up to 32")